PDA

View Full Version : Free Stuff


SmithKid
03-01-2014, 08:05 PM
I have a takeout cam and lifters from my 302. It has very low miles on it. (less than 750 miles I'm sure). It makes decent power, a bit of rough idle, and pulls around 16.5 inches of vacuum. The lifters have been marked and stored to match the proper cam lobe, so I'm confident it can be re-used. FREE, just pick it up from me or reimburse shipping cost.

I also have my take-off front spindle/brake drum setup. These are 5 lug hubs. I converted to Granada discs from another member. These are FREE also.

If no interest is shown in above, I will dispose of it for more storage.

642dw
03-03-2014, 08:45 PM
Free is a heck of a price :WHATTHE: I know I am one of the new kids on the block but I could use the spindles, when I installed my new 65 tie rod ends in the spindles I currently have on the car (65 Falcon or Mustang) I discovered po had done some hockey stuff to make the 64 6 cylinder tie rod ends work and made the spindles sloppy fitting.

I would be more than happy to pay for shipping and if you could take all the brake stuff of off them I would be willing to pay you to make it worth your effort.

Mike

SmithKid
03-04-2014, 12:22 PM
It looks like Mike mand I have made arrangements for the front end parts. Any takers for the cam?

I forgot to mention that I have my fully rebuilt and recovered seat for sale for a reasonable price (make offer). It is recovered with the '65 deluxe blue from Dearborn. It will go to the Monroe swap meet this year if I still have it.

Jeff W
03-04-2014, 01:20 PM
Any takers for the cam?




Have you checked with your wife?

SmithKid
03-04-2014, 04:11 PM
But then what would I do with the lifters? She's more into the natural look, but thanks for the suggestion. You're always appreciated? ;)

Luva65wagon
03-04-2014, 11:26 PM
Jeff - do you have a drill bit that long? Or half that long? I see a couple lamps in my future. [thumb]

Jeff W
03-05-2014, 10:30 AM
Jeff - do you have a drill bit that long? Or half that long? I see a couple lamps in my future. [thumb]

I was thinking we could shoot a hole through it... It works for running wires through 2x4 sill plates:rocker:

SmithKid
03-05-2014, 12:51 PM
I can't help but wonder..... what caliber gun shoots through the length of a cam. Maybe just a V-8 cam and not an in-line 6?
Whoa. Where is this thread going? Hope the moderators don't get after me!

Luva65wagon
03-05-2014, 05:18 PM
Nope - I was wondering the same exact thing... where is this thread going?