Printable View
Hi. I am looking for the upper inside trim rear pillar pieces on my 63 wagon. These pieces cover the headliner. I am not sure if a 61,62 and 63 are the same, but believe they are. Hoping someone here is parting out a wagon and has these parts. Thanks
If you're still looking, here's a set on ebay:
https://www.ebay.com/itm/39324210518...8AAOSwHWBgc5B~
Hi Beerbelly. Thanks for the heads up. I see they are sold, but I I did find another set a couple of weeks ago.....looks like they are getting hard to find. Thanks again.
For anyone also looking. They look a lot like mine in a 64. I think 60-65 should interchange. Opens up some more search avenues
I've been looking (several years) for both front bottom corner pieces for my Ranchero bed trim. Mine were drilled by PO :mad: for soft tonneau snaps....... Anybody?
3d printing?
They would take some work to model, but they are made of plastic. If you could get a reasonablyt accurate model. I'd assume you could print them for $20 each in quantity 30 or so. Might save some by drilling them yourself.