Problem with alignment on my clutch job

Please take a look at this photo, this set up is for a 1969 Ford Mustang with a 200 ci inline six cylinder mated to a heavy duty top loader three speed manual transmission.

I got all the replacement parts I needed, which look identical to the old parts I removed, and things are not lining up.

I replaced the pressure plate, the clutch, put in a new clutch fork, and new clutch release bearing, again, everything that was replaced looks identical to the parts I removed.

I bolted the bell housing on and this photo demonstrates what's wrong. The clutch fork is mounted properly on the fulcrum, it is the same fork as the one that came out and the fork and part number for this year and model Mustang. I'm trying to figure out what's what but thought I'd see what fellow forum members think...

Thanks

Slide the throw out bearing to the right. The curve of the clips should be over the edge of the throw out arm.

I could be looking at the picture wrong, bit to me the throw out bearing is slid all the way to the clips.

I agree with Nathan. The bearing appears to be pushed hard-up against the end of the spring clips where they rivet to the arm. It should have the two clips riding in the recessed valleys of the clutch arm finger tips. This should feel like the natural landing spot for the bearing clips onto the arm.