Printable View
I am putting a C4 behind the 289 that replaced the 200 in the Ranchero. I was told by someone at Dearborn Classics that I would need a column shift control selector insert and that they were no longer being reproduced. Does anyone know where I can get a hold of one of these? Or is this a part that can be machined? Or what my other options, if any, would be?
As always, any and all help is appreciated.
Troy
Have you checked with the other vendors?
Falcon parts? Mac's? autokrafters?
Were they talking about the detent plate? you can modify the two speed one with a little careful filing..
Or
were they talking about the lense that goes on the shifter collar?
Nathan
Falcon parts..
heres a link to the detent plate
http://www.falconparts.com/1960-1964...ENT+-+C-4.html
heres the link to the transmission seletor indacator
http://www.falconparts.com/1965+TRAN...CATOR-C-4.html
Those are the only parts I know of...
Nathan
Thanks Nathan,
I made the mistake of assuming when talking to Dearborn. Should of done some digging.
Troy
Yup. You just need those two parts for the column. You'll also need to make sure the tranny is set up for column. The shift lever should point down.
I guess the Fordomatic 2 speed shift detent is hard to find as I haven't found a listing for it yet. other than the link kenny showed me..
Nathan