Results 1 to 10 of 10

Thread: EFI ready gas tank for '61 Falcon

  1. #1

    EFI ready gas tank for '61 Falcon

    Greetings...

    I'm looking for an "EFI ready" fuel tank for 61 Falcon. I see they are avail for early Mustang but not Falcon. I prefer to get one that already has provisions for the electric pump & vertical style sending unit instead of modifying mine.

    I understand the filler neck location is different... but otherwise I believe the 16 gal aftermarket tanks are the same dimensions and will drop in a Falcon trunk. And it appears that you should be able to adapt/modify a filler neck to mate up properly w/the tank.

    Your thoughts on using/adapting an early Mustang "EFI Ready" tank to a 61 Falcon would be much appreciated. I also understand an "in trunk" non-vented filler is also an option with the Mustang tank.

    Also curious if anyone knows why the filler necks on the early Falcons were at such an odd angle.

    If this subject has been discussed previously, I didn't find it. Pls point me in the right direction.

    Thx- Fred

    Fred Pennington
    '62 Falcon
    289, 4-Spd, 9 in

  2. #2
    Fred,

    Many use the Mustang tank as a swap, but do the in-the-trunk-fill option and negate the rear panel fill (and forever save your paint job). It's a good swap since the odd-angle you speak of is no longer a concern. If you plan to maintain the external fill I think you can still fanangle the connection, but you'll probably need to use your McGyver hat.

    And who knows why Ford could't have designed the filler neck the same on both cars since all the other dimensions were the same.

    On the early Falcon there was a vent tube leading out fumes of the trunk, so you use a non-vented cap in the case of an alternate fill tube (most use a straight F100 filler neck) and the tank vents as needed using the vent tube. If the Mustang tank doesn't give you that vent tube option, I don't suspect it would be hard to add.

    Hope this helps.
    Roger Moore

    63 "Flarechero"
    powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear



  3. #3
    Roger - Thx...

    I've seen that some of the tank mfgs offer an in-trunk fill option. Coincidently, the gas "urped" out of my '61 on the garage floor yesterday but luckly caught it just after it happened... I wasn't as luck on my '62 a couple years ago. You would think the vent tube would help eliminate that. Better check to see if its clogged.

    And I agree that one should be able to modify a fill tube to mate with the tank. Seems very close to the Mustang setup.

    I found it interesting that I posed the same question to every mfg I could find that offers Mustang tanks and most agreed it would fit and one could adapt a filler neck but a couple did not recommend it and none had any first hand experience with the install.

    Regarding the vent... the setup I am considering using includes a vent port fitting on the fuel pump.

    The reason I am researching this is I have a 331 strocker running the MSD TBI with a return and external fuel pump in the '61... would like to get the pump noise down and keep the pump cooler.

    Looks like I will probably take the plunge and let you know how it works out.

    Thx for the feedback - Fred

    Fred Pennington
    '62 Falcon
    289, 4-Spd, 9 in

  4. #4
    FWIW, I have a Mallory EFI pump mounted just in front of my tank for a 331 stroker with Megasquirt. That pump is so quiet it can't be heard at all.
    Patrick Brown
    331 Stroker / T5 / 8" / Wilwood Disks / RRS R&P Steering / Megasquirt EFI


  5. #5
    I have the MSD pump that is bundled with the MSD Atomic EFI. I'm running a "return" system with a regulator so the pump runs all the time. Even with it mounted on isolators in front of the tank, is is noisy at while stopped... don't normally hear it while driving. Maybe just being picky. The pump can run in PWM mode which is quieter but has its own issues with the fuel line pulsing.

    Which Mallory pump are you using? I did a quick look and found a P/N 22257 for EFI.

    And while looking, discovered Mallory was part of MSD... which, as of a couple years ago, is part of Holley.

    Anyway, thx... pls let me know what you are using. It sounds like a good option.

    Fred

    Fred Pennington
    '62 Falcon
    289, 4-Spd, 9 in

  6. #6
    Quote Originally Posted by charlescfp View Post
    Which Mallory pump are you using? I did a quick look and found a P/N 22257 for EFI.
    That is the one. They make a bigger one too if you need it. P/N 29257.

    I had a few noisy carb pumps back when I ran a carb. I hated the noise and was recommended to try a Mallory. It was so great that when I converted to EFI, I switched to the EFI version of the same pump.

    I also run a retun system. I have a fuel rail mounted regulator set to 45psi.
    Patrick Brown
    331 Stroker / T5 / 8" / Wilwood Disks / RRS R&P Steering / Megasquirt EFI


  7. #7
    Join Date
    Dec 2006
    Location
    Mill Creek
    Posts
    1,224

    EFI ready gas tank for '61 Falcon

    I can't find the brand name of my pump, but I sure need a quieter one. What one would you recommend Pat? You can see I have it hanging on a rubber pad to keep vibration down. Larry
    Attached Images Attached Images
    Larry Smith
    1964 Futura
    347 stroker



  8. #8
    Larry,

    Look at the Mallory 29256 for use without a regulator or the 29259 with a regulator. That first one is set to 7psi at the pump and the other is 12psi.
    Patrick Brown
    331 Stroker / T5 / 8" / Wilwood Disks / RRS R&P Steering / Megasquirt EFI


  9. #9

    Spectra Premium EFI Tank

    Curious if anyone has any experience with the Spectra Premium F28AFI (early Mustang) Fuel Tank. They locate the EFI pump and sending unit in the original factory location of the sending unit and fuel lines (i.e., no lines on top).

    My understanding is that it is a quality product. Good price but not much info available.

    Thoughts?

    Thanks

    http://ecat.spectrapremium.com/products/F28AFI

    https://www.summitracing.com/parts/sgt-f28afi

    Fred Pennington
    '62 Falcon
    289, 4-Spd, 9 in

  10. #10
    I'm not familiar with the Spectra. You might look at Fuel Safe as well.

    http://fuelsafe.com/store/fuel-cells...duro-cell.html

    This would be on the high end and would add a measure of safety to the car as well.
    Patrick Brown
    331 Stroker / T5 / 8" / Wilwood Disks / RRS R&P Steering / Megasquirt EFI


Similar Threads

  1. Replies: 3
    Last Post: November 17th, 2015, 06:54 PM
  2. Falcon vs. Tank. Baghdad, Iraq, 1963.
    By ew1usnr in forum Chit Chat
    Replies: 0
    Last Post: June 15th, 2013, 04:51 AM
  3. Window Decals ready to go!
    By redfalken in forum Events and Announcements
    Replies: 18
    Last Post: July 6th, 2009, 09:35 PM
  4. Falcon Flyer Newsletter ready!
    By redfalken in forum Events and Announcements
    Replies: 4
    Last Post: May 28th, 2008, 08:37 PM
  5. Gas tank
    By Amanda23 in forum Parts Wanted
    Replies: 2
    Last Post: April 4th, 2008, 10:27 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •