View Single Post
Old June 30th, 2008, 12:48 PM
Nathan289's Avatar
Nathan289 Nathan289 is offline
Join Date: Oct 2006
Location: Deer Park
Posts: 1,100
good news is my tranny mounts should be here today So I can get that off my work bench..

I just finished replacing the motor mounts..

I replaced u joints becasue i had the driveline out and replaced the rear output shaft seal while the trans is on my bench..

Do you know if the was a bushing where the shift arm meets the shift tube?? Mine didn't have anything and it seems sloppy there, but there might not have been anything..

Reply With Quote