Thread: Wipers
View Single Post
  #6  
Old 12-02-2006, 04:12 PM
Luva65wagon's Avatar
Luva65wagon Luva65wagon is offline
Chapter President
 
Join Date: Oct 2006
Location: Lynnwood
Posts: 4,419
Blog Entries: 4
I recently did the intermittent conversion on my 67 F100 and purchased 3 switch and modules setups just in case I could do it to the wagon and then have one for a spare. You can find these on ebay all the time, but I've found 2 sets at Pull a Part since getting my first one on ebay. It was a piece of cake on the truck because it just plugged in. I'm not 100% sure whether the connector is the same on the Falcon, but it won't be hard to figure out. I used the same diagram Patrick posted, but I also redid this diagram to remove and improve any superfluous information and to actually get it to match my trucks wiring... which may be closer to the 65 wiring than the 79 wiring (on the car side of it all). So have a look at it as well.

As for as the rattle, I agree, you'll need to inspect the mechanisms to see what's loose. It's going to most likely be a bushing somewhere in there.
Attached Images
File Type: jpg wiper-delay-wiring.jpg (58.5 KB, 26 views)
__________________
Roger Moore

63 "Flarechero"
powered by: '65 289-V8 | T5 | 8" TracLoc rear


Reply With Quote