If they are not, I have some upper and lower hinges in my bin of parts. They are not NOS, but I think I did all new bushings and pins in them. Or have them. I can look at them if you want me to, unless NOS is what you're after.
If they are not, I have some upper and lower hinges in my bin of parts. They are not NOS, but I think I did all new bushings and pins in them. Or have them. I can look at them if you want me to, unless NOS is what you're after.
Roger Moore
63 "Flarechero"
powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear
Purchased the widely available repair kits for both sides and installed them back in 2008. Less than 5,000 miles later the cam plate rivet failed on one side and a cam plate pin on the other side just fell out. Perhaps the kits are junk or my hinges are too far gone to re-rebuild.
Not necessarily seeking NOS hinges.
Interested in what you may have
Thanks in advance,
Ted
I'll dig them up and let you know soon.
Roger Moore
63 "Flarechero"
powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear
Bookmarks