Transmission Swap

**Nathan289** · December 10th, 2012, 07:13 PM

Stock fox body mustang goes right through the floor where the cross bracing is..

But its a great location. The s10 mod is more than just the tail shaft.. theres internal parts that need swapped..

It comes through near the stock location.. not bad but i had to lean forward alittle when shifting..

There is a guy here in spokane that parts out foxbody mustangs.. i can find his number for you if you want

**BadBird** · December 11th, 2012, 03:58 PM

Thanks Nathan. I realize a few of the internals of the S10 are going to be needed. I see that i will need to change the speedo gear location has to be changed and other items will have to be addressed.

I already have a hole in the floor where my shifter comes through now. I am hoping the S10 location is the same. I also don't want the shifter to be too far aft because I have the console installed.

I would really appreciate any help with your friend on locating the parts i need. Thanks very much. Larry

**Nathan289** · December 11th, 2012, 05:09 PM

With either option it will put the shifter in the center of the hump.

With the s10 option puts it close to the stock location just centered.

I'll find noah's number for you..

Nathan

**BadBird** · December 11th, 2012, 08:45 PM

Thanks Nathan. My cutout is right it the middle now so the S10 location should work perfect. Larry

**BadBird** · December 15th, 2012, 07:46 PM

Nathan, were you able to find Noah's number. Thanks, Larry

**Nathan289** · December 15th, 2012, 08:57 PM

Larry,

No i must have deleted it from my phone and he hasnt returned my emails.

He normally posts on spokanes craiglist usually in all caps. I havent seen any listings in a while too.

He supposedly sells on ebay too.

I bought my t5 from a seller off ebay from texas... rebuilt with warranty no core exchange. Shipped to my door $750..

Nathan