Any help most appreciated!
Any help most appreciated!
Don Bartlett
Federal Way, WA
61 Four Door Sedan
144-6, 3 on the tree
Got a photo of one - maybe the other side? I have a few I have no idea what they fit yet.
Roger Moore
63 "Flarechero"
powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear
Here are a few pics of the other side (which I powder coated, but not looking for a pretty one...just looking for the correct one...) Thanks!
Don Bartlett
Federal Way, WA
61 Four Door Sedan
144-6, 3 on the tree
Just getting this up top before the weekend is over...anyone see one of these driver side 61 front bumper brackets in a box lying around their garage?
Don Bartlett
Federal Way, WA
61 Four Door Sedan
144-6, 3 on the tree
I have the correct side you need - if only you had a 62 or 63. It's very close, so if you totally strike out, I'm sure some creative welding could get this one to match.
Roger Moore
63 "Flarechero"
powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear
After posting this I spun the thing around and see it is the same side as yours but a different year.![]()
Roger Moore
63 "Flarechero"
powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear
The one I need to replace is the one I thought was the "good" one...until I got a good one. Then figured out this one is bent-just not as bad as the other side. It's not ridiculously bent- but bent enough to make a difference and it is sort of a "twist" bend in two directions. Has anyone had any experience trying to heat something like this up with a torch and bend it back into place?
Don Bartlett
Federal Way, WA
61 Four Door Sedan
144-6, 3 on the tree
Bookmarks