There's some rust inside my (4)doors. Its not horrible, but I figure I might as we'll take care of it before I finally paint them. With all the layers of paint on the outside, there's going to be some cost to removing it all. I found a place in Eugene that will dip them to remove paint, remove rust, and treat for rust...$80 per door which doesn't seem too bad...except I have to get them to Eugene and back.
Anyone have any experience with dipping for rust?
Is it better to just blast them inside instead? (Steve? You're a lot closer now that I think about it. What about powder coating just the inside?
Anyone know of someplace closer than Eugene that does dipping?
Appreciate all advice!