The morning temperature was 52° and clear with no rain and I drove my Falcon to work. I noticed a few minor glitches.
The car stalled after I had pulled out of my driveway.
The windshield became badly fogged and using the defroster made it worse.
The driver’s door had become difficult to unlatch from the inside and I needed to pull up sharply on the handle to open the door.
Hmmm.
1. After lunch I went out and started the engine and sped the fast idle up from 600 to 800 rpm in Park to minimize the cold stall potential.
2. After getting home I worked the door handle up and down and noticed that the latch wobbled. I found that the crosshead screw below the latch on the trailing edge of the driver’s door was loose. The picture shows the loose screw above the left top edge of the specification plate. I tightened the screw and the door opened properly. Yay!
1-DCP_0072.jpg
3. I cleaned the inside of the windshield with "Invisible Glass" glass cleaner. Hopefully, that will take care of the foggy glass.
We are getting hit by some kind of polar vortex this evening. Tomorrow morning is forecast to be 39 degrees, clear, with no chance of rain. Perfect! I'll get to try out my corrected door, see how the engine responds to a cold temperature, and I'll get to run my heater and see if the windshield still fogs up.
As a side note: While driving home this afternoon, traffic was stopping for a red light and a guy was trying to pull out into the street from the right. I was on the inside lane, but I slowed down and waved at him to enter in front of me. He waved back for me to go first. Wanting to get out of his way, I punched the gas and ...... my tires squealed! On dry pavement, and without even meaning to, I spun my tires! Yea! I have about 8,000 miles on the rebuilt Challenger 260 engine, and as it loosens up it just keeps performing better and better.
Bookmarks