Duh. Now I see where you said you bought the brackets. Sorry.
Duh. Now I see where you said you bought the brackets. Sorry.
Roger Moore
63 "Flarechero"
powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear
All good. Bill Wilson used to make the brackets and retired. Here's the website for the individual that took it over.
http://www.copperstatecomponents.com/
I actually paid more for the brackets than the seats! On the winter to do list but the Falcon to do's and the Mustang to do's are taking precedence at this point.
Followed your thread on FTE - wish I lived closer to learn from you.
Thanks - but learn "along with", perhaps. I may post a lot, but don't mistake that for knowing. I'm always learning from my mistakes along with the rest of you and post what I know from doing that. Just been at it since I was 10, so I tend to have a lot of mistake-learning in my past to choose from.
I remember hearing the brackets were costly. Can't recall if it had already shifted hands, or was just in the works. I wanted buckets, but not "that much." I think I paid all of $50 and a couple cans of dye for the leather seats in it now. It takes me to the dump, swap meets, and hardware stores and that's what I built it for.
Roger Moore
63 "Flarechero"
powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear
Update - Cory was able to locate a Comet console (practically identical to the Falcon). Can't wait to see how it will look in the truck
Scott Zimmerman
'65 Falcon Futura 2 door hardtop, 289 V8
I was actually lucky and scored two consoles. One in better condition than the other. Should receive them in the next week or so.
Bookmarks