I need to find a good carburetor person. Any suggestions ?
I need to find a good carburetor person. Any suggestions ?
What kind of carburetor and what kind of work does it need? I've been known to fix 1 or few hundred of them.
Roger Moore
63 "Flarechero"
powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear
200 6 cyl engine with holey carb. Runs very rough when cold better when warm but still crappy. Misses and sputters on slow climb like my driveway . Very good compression , electronic ignition , new plugs and wires , fuel pump , filter , Wife says it pings when I get into the gas but I am almost deaf and don't hear it.
Fell free to call me
Last edited by Luva65wagon; October 27th, 2017 at 05:52 PM. Reason: Removed phone number for security reasons...
Ric, I'll give you a call Friday when I'm available next.
I assume you've checked timing on this as well? Pinging, if it is happening, would point to timing being too far advanced. Also, the Carb would need to have the spark control vacuum source. All stuff to check while you're at it.
The Holley 1 barrel is notorious for having issues due to warping. Actually, most 60 y.o. carburetors are pretty tweaked by now. I've been able to work past some of these issues before, but some I've seen are a too far gone. In these cases you'll need to be prepared for plan "b".
Will touch base tomorrow.
Roger
Roger Moore
63 "Flarechero"
powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear
Thanks for calling I will check my voltage today and the timing too. I am looking forward to getting it over to you and having you help troubleshoot my issues.
Thanks again
Ric
No worries Ric. I'll text you over my address this week so you will have it.
Roger Moore
63 "Flarechero"
powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear
LOL well I figured out that I am getting 9 v to my ignition but can't figure out which is the pink wire. Good grief
Ric
Bookmarks