Thanks guys... the engine isn't your typical S550 Mustang 2.3EB. We did a bunch of work to her before we dressed her in 2.3EB tin. The block is a 2014 2.0 block with 2.3 stuff. A 2016 2.3 Focus RS (FoRS) head and turbo were also added as well as upgrading the cams, Multi layer headgasket, ARP hardware, balance shaft delete, upgraded oil pump and full remote oil cooling system, etc. With all that and a custom tune she will be closer to 430Whp than the typical mustang 310. More from today... I hate nasty weather, so alot of this was done in the shop where its warm.
Tomorrow is supposed to be better, hopefully we can get the entire front clip on and gaps run. I need to decide on hood pin positioning and get the scoops cut for the heat extractor openings. I already have some additional welding to do on the hood so I might as well get the holes punched and the latches recessed.
20210501_120528.jpg20210501_171837.jpg20210501_171843.jpg20210501_171918.jpg20210501_172316.jpg20210402_125632.jpg20210428_134332.jpg
Anybody close know a guy that can do CF or fiberglass moulds? I am looking to do some custom stuff and would like to re-pop most of it... Let me know, if y'all have a lead.
Bookmarks