Collector car insurance

[silverbird]

Thank you Roger and Patrick for your helpful information about insurance. Since I do not use my Falcon as a daily driver anymore, I cannot see paying high monthly premiums. I also have recently obtained collector plates. Off the subject a little ,but I wanted to endorse Jake, at Original falcon interiors. He did a superb job recovering my seats in the original Rangoon red. I did the carpet and thats another story. Hope to see you guys at a meeting in the future. thanks again.

Sean

[silverbird]

Sorry Jeff, A thank you for your response as well.

Sean

[Jerry Kirby]

Sean,

I am just about ready to do the carpet on my '65. The one I am going to install is supposed to be already cut to size. Can you give me any insight into the install ? Any pitfalls, etc. I was wondering if any one knows an easy way to mark the holes for the seat belts etc. and now I am totally off the original thread.

[silverbird]

Hi Jerry,

Installing my carpet didn't turn out as bad as it was looking. I had some issues with my rear carpet peice which came up short. I was able to use my wife's clothing steamer to stretch it. I also spent time smoothing all the wrinkles out. I would use some 3m spray adhesive to tack the corners down and carpet to the padding. Lining up the seatbelt mounts was a little tricky. I would start from one side making sure you have enough carpet to tuck under each threshhold plate before you cut the holes in the carpet. I cut a small hole in the carpet over the mount and pushed it down over whick made a snug fit. I have heard that some people spray down the carpet first to relax it for a better fit. I hope this helps you. Dont,t forget to walk away for a while if you get frustrated.

Sean

[Luva65wagon]

Hey Jerry, I usually lay out the carpet and then take a poker, like a toad stabber, to locate the hole edges, then a sharp knife into the hole and cut a perfect circle, using the hole as a guide. Helps to find screw holes as well. Larger holes, I try to leave that to precise measurements from key components, or if, like a shifter hole, you can get a rough location to start and then pull the carpet over and continue to trim away a little at a time until it is all the way down.

[cometcougar]

I just put new carpet in my Comet this weekend. All went well. One way I do holes is by using a soldering iron to actually melt through the carpet - such as the holes where the front seat tracks go through the floor, seat belt holes, etc. The heat sort of "cauterizes" the loops so they don't unravel.

[pbrown]

Guys,

If we are going to talk carpet, let's start a new thread. This topic is for insurance.

[Sedanman]

Silverbird,

I have ANPAC insurance, and when added up I think the falcon costs me less than $10/month for full coverage. I don't do it so much for the full coverage (my car's only valued at about $3k right now, and I've got more than double that into it), but the cheap rates since I drive it so little. The only catch is you have to have another car on the same policy as a daily driver, and the collector car has to be in a secure garage space.