Source for small parts?

[Luva65wagon]

I'm pretty sure the screws can be found in stainless at either Lowes or at a Tacoma Screw, which either you should have within driving distance.
If not, I'm sure I may have them if you can describe them.

The plastic inserts, if you are talking the parts that hold the rods to the handles/latch assembly etc, you can get these at Wesco or any other auto-body supply. I'm pretty sure I have a few around here as well and will look over the next couple days to see if I have new or originals and home many.

I'm not sure what the headliner retainer is (I have a 65 wagon, so it may not have them), but again, if these are stainless screws, see item #1 above for these too.

[ichthos]

Roger, I am not sure what the screws look like that hold the instument panel in place. If I had even one that was correct, at least I could match it up somewhere. The retainers are an odd looking piece that fits into retangular holes that keeps the headliner in place on the sides. The plastic pieces I am talking about are inserted into the top of the door and guide the lock as it goes up and down. Again, I do not know what one looks like originally, but if I even had one, I could try and match it up. I frequent ebay, and I will try your suggestions. I just recently found out about the upholstery shop in Seattle, and I plan on going there this summer to get some estimates. Thanks again for your help.
Kevin

[Luva65wagon]

I can look at one of mine on my dash panel and let you know.

I think the headliner pieces you are referring to are for the window lacing, not the headliner per se. I'll take a close up of what I'm thinking you are asking about and try and post a picture in the next 12 hours or so.

I know the parts you are seeking for the door lock pulls. I bought new ones myself for the job I'm doing on mine. I pulled the drivers side out today intact and if I get the passenger side out I'll let you know just in case you want them. I did replace them in my friends Mustang as well, and I think I bought an extra set for that too on accident. Will look.

[Luva65wagon]

OK, I assume these are all the items you are seeking:









I'm pretty certain you can round up the screws locally. There are 4 of the longer screw and 2 of the shorter. The shorter screws have the sharp point flattened to avoid poking wires on the lower part of the dash. These are 5/8" long and stainless. The upper (longer) screws are stainless as well and 1" long. They both appear to be #6 screws. I'm sure I have these as well. I've got a lot of stainless screws.

I have two of the lockrings, which cleaned up nice. I posted a dirty picture of one . No... dirt, like as in grimy.

I don't have any of the clips that are not in the car. These would have to be found in a parts car I think. Call Jake at OFI to see if he has any.

[ichthos]

Thanks for the pictures. I have a couple of spare parts cans I will look through now that I know what they look like. When I bought the car there were pieces everywhere. I collected everything I could find and put them in cans. I found where most of the parts went by going to the junk yards early on, but it is pretty much impossible to do that now.

The top picture is not what I am looking for for the headliner. The headliner has retaining strips on either side of the headliner. The pieces that hold in these strips fit into rectangular holes and are about 1/2" long with two "wings" sticking out on either side. You wouldn't be able to see them unless you had the headliner removed.