Rainier Falcons > The FalconForum  

Go Back   Rainier Falcons > The FalconForum > General Forums > Tech Talk

Thread Tools Display Modes
Old 06-03-2018, 05:34 PM
Notar61 Notar61 is offline
Active Forum User
Join Date: Oct 2014
Posts: 57
Lift points for a 170 engine


I have a 1961 with a 170 engine that I need to remove from the car.

What is the best way to hook it up to my lift?

Should I use some lift ears or just high grade bolts and chains?

What are the best locations on the engine to attach to?

I have access to a 2 ton lift with an engine leveler bar. Just wasn't for sure the best way to get the engine chained up to the lift.

Any help or info is appreciated! Thanks!

Reply With Quote
Old 06-04-2018, 11:15 PM
Luva65wagon's Avatar
Luva65wagon Luva65wagon is offline
Chapter President
Join Date: Oct 2006
Location: Lynnwood
Posts: 4,377
Blog Entries: 4
Ford originally used hooks to grab the intake manifold log. You'll see holes cast in between runners opened for this. You can use lift ears or chain and pull the exhaust manifold for those bolt holes. Use good grade 5 or 8 bolts and make sure you take up bolt slack. Bolts allowed to bend are more apt to break that even smaller bolts tightened. Hanging on one side only will tilt the motor as you lift it, but there are not a lot of good boss bolt holes on the distributor side. Pulling it this isn't as big a deal as when you are trying to put one in.

No matter what, lift smart.
Roger Moore

63 "Flarechero"
powered by: '65 289-V8 | T5 | 8" TracLoc rear

Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
PerTronix vs Points ew1usnr Tech Talk 6 09-09-2016 08:31 PM
I found the leak points. ew1usnr Tech Talk 7 02-28-2015 03:10 PM
All Points Bulletin. Rocker arm assembly needed Nathan289 Parts Wanted 3 10-03-2014 09:41 PM
Front end lift tjmcb Tech Talk 3 10-03-2014 06:37 PM
Anyone Need an Engine? MacDee Chit Chat 0 01-21-2010 12:43 PM

All times are GMT -7. The time now is 07:22 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.