Tie rod ends. L & R, or not?

[ew1usnr]

Dennis, Where did you buy your "easy turning "elastomer" swivel spring mounts" (for the front)
and do those install with the spring end side towards the outside of the car?
Thanks...

Hello, Don.

I ordered the "High Performance Coil Spring Perches" off e-bay for $103 from Maryland Mustang. These are from a different dealer but are the same part for $120: http://www.ebay.com/itm/C4DZ-3388-HP...35b532&vxp=mtr

I looked at the driver's side spring (left) and the lower cut-off end of the spring faces inward. This shot is looked from the front to the rear. The spring end is behind the tab that is on the right in the picture. On the lower left side of that tab you can just barely see the cut-off end of the spring. (I had the Moog 8088 spring shortened by one coil length to make the car sit level.)
1-DCP_6029.JPG

Here is a photo of the elastomer perches. You can see where the tab is on the perch. Those tabs are positioned on the outward side on my car.
Spring perches with synthetic elastomer bushings.jpg

Here is a shot from the back of the spring looking forward.
2-DCP_6030.JPG

Thanks, Dennis.