Results 1 to 15 of 16

Thread: fuel tank '65 station wagon

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    joe demoruelle Guest

    fuel tank '65 station wagon

    OK I've been looking everywhere for a replacement gas tank for 1965 station wagon. Good Grief... they are excluded from everything I've seen. Where can you get one? The one I have was installed upside down so that the filler hole was on the right side.... gas spilled out every time I turned right! AND the sending unit was upside down also, so the fuel guage read empty all the time.
    There must be one out there.

  2. #2
    They are available new. I bought mine from maryland mustang it was off ebay.. They will run about 250$..
    There is a gas tank.com place that sells the exact same tank for Near $500..

    I think the tank was made by American design out of canada..

    Nathan
    Nathan and Jen Cooper
    63 Sprint Hardtop "Dollora"
    63 Super deluxe squire wagon "Mayble"
    * this spot is vacant for future project*

  3. #3
    I've not seen them listed for the 64 and 65 wagons -- only the 60-63. I see those everywhere. Is this really for the 64/65 wagons Nathan? From a Mustang house?

    Assuming there is something we're missing here, does anyone know what, if any, difference there is between the 60-63 and 64-65 wagon tanks? Can any of you 60-63 wagon owners crawl under and take some measurements? I'll measure mine up tonight. Knowing this may help us 64-65 owners know what mods are needed to adapt the earlier tank.

    FWIW, my tank appears good (knock on wood), but I have always lamented they don't appear to be repop'd for the 64-65 wagons.
    Roger Moore

    63 "Flarechero"
    powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear



  4. #4
    i think the mustang vendors are just filling a void.. has nothing to do with mustangs and falcons using the same tank.
    Nathan and Jen Cooper
    63 Sprint Hardtop "Dollora"
    63 Super deluxe squire wagon "Mayble"
    * this spot is vacant for future project*

  5. #5
    Quote Originally Posted by Nathan289 View Post
    i think the mustang vendors are just filling a void.. has nothing to do with mustangs and falcons using the same tank.
    There is a void? I've not noticed.


    YES there is a void -- they voided making 64-65 tanks!
    Roger Moore

    63 "Flarechero"
    powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear



  6. #6
    joe demoruelle Guest
    well with all this information now I'm totally confused... but the pictures helped... THANKS. Joe

  7. #7
    Joe,

    I think the bottom-line is that they only make tanks for 60-63 wagons.

    By looking at the picture Jeff posted of his you should be able to get one of those and with very little effort get it to go into your '65 wagon by making sure the tank is mounted to the drivers side so the filler hose connects and the fuel sender being on the left side rather than facing forward means the fuel hose connection to the line running forward to the engine is a bit longer to reach the side-mounted sending location. I am guessing a 65 sender fits the 60-63 tank, since they appear to be about the same thickness of tank and the sender is up high like my sender was.

    You may need to put something next to the tank on the passenger side to take up some slack in the straps so they will tighten up since the 60-63 tank is a bit narrower. You could probably use some plastic PVC pipe or something. It would probably be nothing bigger than a 1.5" diameter piece the length of the tank. Who knows, it may not need anything.

    So maybe, what you could do is to take some pictures of what you have and from those we can brainstorm the actual best thing to do.
    Roger Moore

    63 "Flarechero"
    powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear



  8. #8
    Are you saying you can't use quick reply? I just used it here, though normally I only use Post Reply.
    Roger Moore

    63 "Flarechero"
    powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear



  9. #9
    joe demoruelle Guest
    I've learned that the F-55B is for the Falcon model while the Futura model takes the F-28B. If this is correct it might clear up peoples problem who are looking for a gas tank. The F55B has the filler hole in the middle, while the F28B has it on the left side.

  10. #10
    But Joe, I believe all wagons have their filler-neck on the drivers side quarter panel and the fill neck on the tank is on the drivers side too (obviously) and about a foot from the rear of the tank. So I don't see this as being a Futura model, or not, issue -- unless I'm missing something. I don't see how the model has any bearing on this, since that's trim-level stuff.

    I'm going to take some very detailed measurements tonight of mine, which is not a Futura wagon, and maybe Jeff or Nathan can measure up their wagons (both are round-body wagons) to see how they differ.
    Roger Moore

    63 "Flarechero"
    powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear



  11. #11
    Here's some pictures with measurements from my wagon. Perhaps some of you other wagon owners can do a comparison from these.

    I also noticed a fitting on the top of the tank I never noticed before. Is this a potential vent? I have no vent hose on this tank and everyone I ask has a vent hose going somewhere. Question I guess would be, if I hooked up a vent tube, where does it go safely so as to not overflow or vent into the car?
    Attached Images Attached Images
    Last edited by Luva65wagon; June 7th, 2010 at 09:09 PM.
    Roger Moore

    63 "Flarechero"
    powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear



  12. #12
    Join Date
    Oct 2006
    Location
    Seattle
    Posts
    1,430
    I didn't jack up the car to get nice pictures like Roger.

    My 1963 tank is a bit smaller but the major difference appears to be that the pick-up tube and sending unit are on the side of the tank rather than on the "front" as on Rogers 1965.

    I don't think it would be too big of a project to "make it work" with some modifications to the wiring and routing of the pick-up tube.

    NOTE: My tank is a repop installed shortly before I bought the car. This may not be the OEM configuration although the plumbing looks untouched.
    Attached Images Attached Images

  13. #13
    Join Date
    Oct 2006
    Location
    Seattle
    Posts
    1,430
    Quote Originally Posted by Luva65wagon View Post

    I also noticed a fitting on the top of the tank I never noticed before. Is this a potential vent? I have no vent hose on this tank and everyone I ask has a vent hose going somewhere. Question I guess would be, if I hooked up a vent tube, where does it go safely so as to not overflow or vent into the car?

    Here is where my vent tube routes - jw
    Attached Images Attached Images

Similar Threads

  1. 1967 Falcon Futura Station Wagon For Sale
    By kirkearl in forum Cars and Parts For Sale or Trade
    Replies: 1
    Last Post: August 28th, 2012, 01:50 PM
  2. falcon futura station wagon 1965
    By joe demoruelle in forum Show Off Your Ride
    Replies: 1
    Last Post: May 25th, 2010, 09:08 PM
  3. Converting fuel filler
    By BillP 98201 in forum Tech Talk
    Replies: 7
    Last Post: February 21st, 2010, 08:49 AM
  4. For Sale: 1967 Falcon Futura Station Wagon
    By Unregistered in forum Cars and Parts For Sale or Trade
    Replies: 0
    Last Post: October 26th, 2009, 03:27 PM
  5. Fuel starvation
    By Luva65wagon in forum Tech Talk
    Replies: 11
    Last Post: September 2nd, 2008, 11:29 PM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •