Results 1 to 4 of 4

Thread: All Points Bulletin. Rocker arm assembly needed

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1

    All Points Bulletin. Rocker arm assembly needed

    Hello,

    So motor is all rebuilt.. good compression, good oil psi.

    Has a rattle or even a knock almost..

    So I check this and that and have just about eliminated everything until Roger and my machinist say check the rocker arm shaft..

    So needless to say mine is bent has a bow in it. And is scored really bad from lack of oil or whatever..


    So I need a rocker arm shaft assembly for a mechanical lifter setup..

    Shoot me a pm if anyone has a spare
    Nathan and Jen Cooper
    63 Sprint Hardtop "Dollora"
    63 Super deluxe squire wagon "Mayble"
    * this spot is vacant for future project*

  2. #2
    Nathan - I found one, but it's not the good one I had - so it is probably on a Comet, best guess.

    I have it boxed up and will ship it to you tomorrow and hopefully you can use it.
    Roger Moore

    63 "Flarechero"
    powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear



  3. #3
    Roger,
    Thanks..

    I got mine all measured this morning.

    The shaft is .769 or .011 below specs plus it bent.
    I have 10 rockers that are use able and I have 2 that are at limits.

    Worst case scenario I could buy a new shaft and scavenge a couple rockers from yours.

    What do I owe you for shipping?
    Nathan and Jen Cooper
    63 Sprint Hardtop "Dollora"
    63 Super deluxe squire wagon "Mayble"
    * this spot is vacant for future project*

  4. #4
    Don't worry about it. I suspect someday I'll need something you have and you can return the favor. I hope there are good bits on it for you.
    Roger Moore

    63 "Flarechero"
    powered by: 347ci stroker | Tremec T5 | 8" 3:45 TracLoc rear



Similar Threads

  1. I found the leak points.
    By ew1usnr in forum Tech Talk
    Replies: 7
    Last Post: February 28th, 2015, 02:10 PM
  2. Falcon run assembly party
    By doghows in forum Events and Announcements
    Replies: 16
    Last Post: October 19th, 2013, 10:15 PM
  3. Final assembly party
    By doghows in forum Events and Announcements
    Replies: 44
    Last Post: September 29th, 2013, 09:22 PM
  4. Clutch Pedal Assembly
    By BadBird in forum Parts Wanted
    Replies: 8
    Last Post: March 22nd, 2013, 08:41 AM
  5. Rocker Shaft
    By MacDee in forum Tech Talk
    Replies: 3
    Last Post: January 13th, 2007, 11:40 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •