I was checking the four bolts on my bell housing for tightness and I noticed a fifth hole and I removed one of the four bolts and threaded it into the fifth hole, and it caught.

I have a Ford six cylinder 200 cubic inch motor from 1969 (in my 1964 Falcon) that uses the two bolt starter and 9 inch clutch, and the larger heavy duty 3 speed toploader transmission.

The bell housing for this setup uses four bolts, at least that's what I removed when I did some work recently.

How many bolts does your bell housing use to bolt to the motor? The bell housing to the motor, not the trans to the bell housing.

Thank you