Results 1 to 2 of 2

Thread: cylinder head question

  1. #1

    cylinder head question

    Hi , I´m on my way to bolt on the cylinder head but I don´t know how hard to pull/screw the bolts (Nm) , can you guys help me ?

    Matte

  2. #2
    Here's all the info you should need:

    http://www.classicinlines.com/SmallSixSpecs.asp

    It has to be done in 3 steps of increasing ft./lbs. and also in a specific sequence. You should also chase the threads in the bolt holes to make sure they're clean and use some Moly lube.

    Also, there's a bolt on the front that will go into the blades of the water pump if you're not careful. You may need to grind a little off to make sure it clears. That bolt is also wet so you'll need some sealer on it.

    You may know all this but I thought I'd throw it out there just in case!

    Kenny Likins
    Ballard, Seattle, WA
    www.redfalken.com

    `62 Tudor Sedan (`69 200, C4, 8-inch 4-lug 2.79 rearend, Duraspark II, MSD, Weber 32/36 DGEV)

Similar Threads

  1. Straight Six cylinder head needed
    By redfalken in forum Parts Wanted
    Replies: 3
    Last Post: May 22nd, 2010, 06:57 AM
  2. offy trip carb set up and head
    By expmx1 in forum Cars and Parts For Sale or Trade
    Replies: 0
    Last Post: February 15th, 2010, 02:48 PM
  3. cylinder head movement side to side
    By Sedanman in forum Tech Talk
    Replies: 5
    Last Post: October 28th, 2009, 11:19 PM
  4. Tools for cyl. head porting
    By Sedanman in forum Tech Talk
    Replies: 8
    Last Post: August 16th, 2009, 12:38 PM
  5. head nods all around
    By dave b in forum Introductions
    Replies: 4
    Last Post: February 1st, 2008, 06:11 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •