Originally Posted by
Luva65wagon
It should hold due to a cam section on the very edge of the turn signal switch, which is below that shiny upper plate. It is held in place until the part mounted up under the steering wheel hits either of the little spring loaded parts and pushes it back to center. So, from this picture, I can't see anything broken or wore out below that shiny round part out on the very edge just past the switch. Attached is a picture of a new switch and you can see at the up/down/up plastic part the end of the shiny part rides up and down on. Yours might just be so worn it can't hold anything in place.
Bookmarks