Rainier Falcons > The FalconForum  

Go Back   Rainier Falcons > The FalconForum > General Forums > Tech Talk

Reply
Thread Tools Display Modes
  #1  
Unread 02-22-2015, 07:59 AM
ew1usnr's Avatar
ew1usnr ew1usnr is online now
Senior Forum User
 
Join Date: Dec 2012
Posts: 846
A brighter turn indicator

My turn signal indicator light is not very bright and I cannot see it when the sun is behind me. Couple that with my not hearing the relay because of wind and traffic noise, and with my cancel not always cancelling, I sometimes embarrass myself by driving with the turn signal on.

The stock 1895 bulb is 2 candle power (cp), 0.27A * 14V = 3.8W, 2000 hour life

I had earlier replaced all the instrument panel bulbs with a 50% brighter 1816 bulb with 3 candle power , 0.33A * 13V = 4.29W, 1000 hour life. Those helped some, but still did not seem especially bright.

I just now installed a 6.4 candlepower Halogen instrument panel bulb replacement: Osram Sylvania 64111 5 Watt 12 Volt, T2.75, Ba9S Miniature Bayonet base, Clear, 240 Hrs Average Life, Halogen Light Bulbs
See: http://www.amazon.com/Osram-Sylvania.../dp/B007TTNUZC $2.99 + $4.50 postage

Halogen bulbs are hotter and require a ceramic base socket, but this should be OK since it is an intermittent flashing light that will not stay on for long. It is brighter but has a much shorter 240 hour life vs the 2000 hr life of the stock bulb. But 240 hrs should still be good for several years.

I also ordered a “12V 2 Pin Motorcycle Motorbike Flasher Relay Turn Signal Indicator Beeper” off e-bay for $2.59 + $1.99 postage from Shenzhen, China = $4.58. It has a built-in beeper that will beep with the turn signal; - beep -beep -beep . I'll let you know what I think of it after I receive it and try it out:
Motorcycle flasher with beeper.jpg

"Universal 2 pins flasher relay, can be fitted on most cars or motorcycles."
Flasher with beeper 4.JPG

"Wide input range, can be used on DC 6V to DC 12V motorcycle. Standard electro-mechanical type. Inbuilt beeper. Designed for tungsten light bulb turn signal lights. Specification: Input voltage: DC 6V~DC 12V, Input current: 4A~6A, Color: Orange."

Flasher with Beeper 3.JPG

Flaher with beeper 2.JPG
__________________
Dennis Pierson
Tampa, FL
"The Wonder Falcon"

'63 Futura Hardtop (260, Ford-O-Matic, bench seat)

Last edited by ew1usnr; 02-22-2015 at 09:01 AM.
Reply With Quote
  #2  
Unread 02-26-2015, 04:10 PM
ew1usnr's Avatar
ew1usnr ew1usnr is online now
Senior Forum User
 
Join Date: Dec 2012
Posts: 846
Wires and bulbs

When I drove to work this past Monday morning the new halogen turn signal bulb seemed to burn out about halfway to work. I used the right turn signal and there was no indicator light. Darn it! I figured that the halogen bulb must not have been able to deal with the on off on off. But, on the way home I saw that indicator bulb was flashing while using the left turn signal. When I got home I saw that the front right front parking light worked but not the turn signal. I figured that the bulb was bad and bought a new one from AutoZone (get into the Zone, AutoZone), ... but the turn signal light still did not work. I must have pulled the turn signal lead loose when changing the indicator bulb.

This evening I finally got another chance to mess with it. I looked under the dash and saw a loose hanging wire with a female socket terminal and then found another loose green wire coming from the steering column that had a male terminal. Figuring that I had found the disconnect, I plugged the two together and ….. my windshield wipers came on when I turned on the right turn signal! The regular windshield wiper switch worked also. That loose female terminal is evidently where an optional windshield washer would plug into. Wow! My Falcon is still revealing secrets. I looked again and found another loose green wire with a female socket. I plugged the two green wires together and, voilą! The turn signal is working again. I can drive my car to work tomorrow morning.

I'm a happy dancing bananna. =>

ford-better-idea.JPG
__________________
Dennis Pierson
Tampa, FL
"The Wonder Falcon"

'63 Futura Hardtop (260, Ford-O-Matic, bench seat)

Last edited by ew1usnr; 02-28-2015 at 05:52 PM.
Reply With Quote
  #3  
Unread 03-07-2015, 02:39 PM
ew1usnr's Avatar
ew1usnr ew1usnr is online now
Senior Forum User
 
Join Date: Dec 2012
Posts: 846
Beep beep.

I received my beeping turn signal flasher! It really is loud. It does not have an on-off on-off beep. It has an alternating high-pitch low- pitch beep that sounds like a British police car.

The sound emits from a directional horn:

DCP_0049.jpg

I lowered the sound level by packing the horn with two foam ear plugs and securing them with a piece of cellophane tape.

DCP_0051.jpg
__________________
Dennis Pierson
Tampa, FL
"The Wonder Falcon"

'63 Futura Hardtop (260, Ford-O-Matic, bench seat)

Last edited by ew1usnr; 03-07-2015 at 05:02 PM.
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
1964 Ranchero turn signal cam Hal Cogburn Parts Wanted 2 06-28-2014 06:56 AM
turn signals quit working.. sort of? Nathan289 Tech Talk 3 05-23-2010 12:05 AM


All times are GMT -7. The time now is 01:31 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2012, vBulletin Solutions, Inc.